- Posts: 5853
- Thank you received: 0
faawrenchbndr wrote: To check and see if your pins are rotating, cycle the charging handle and observe the hammer pin when the trigger is pulled. does it rotate? Many will move about thirty degrees when the hammer drops.
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
faawrenchbndr wrote: Technically, most all ARs do this. It is up to you if you care to install oversize pins or anti-rotation pin set. Many do not worry about it unless it is a high use auto receiver
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
faawrenchbndr wrote: To check and see if your pins are rotating, cycle the charging handle and observe the hammer pin when the trigger is pulled. does it rotate? Many will move about thirty degrees when the hammer drops.
Please Log in or Create an account to join the conversation.
SOC wrote:
Just passing on what they sent to me.faawrenchbndr wrote: Sounds familiar...........wonder why? :whistle:
Please Log in or Create an account to join the conversation.
faawrenchbndr wrote: That would be my bet......154"
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
SOC wrote: Busted out the calipers as well as the SD-E, GA pins and a set of KNS pins.
SD-E hammer = .1555
SD-E trigger = .1555
SD-E sear = .1555
SD-E pins = .1540
KNS pins = .1530 (On package it says .154)
This image is hidden for guests.
Please log in or register to see it.
I wonder what the KNS .1555 pins actually measure?
Anyone want to trade a set of .1555 for a set .154?
Please Log in or Create an account to join the conversation.
Please Log in or Create an account to join the conversation.
All content of this site is copyright 2003 - 2017
AR-10(T)™, AR-10™, are trademarks of ArmaLite, Inc.®
AR10T.com is NOT endorsed or affiliated with ArmaLite, Inc.®